General Mathematics

   

Optimization of WEDM Parameters for Super Ni-718 using Neutrosophic Sets and TOPSIS Method

Authors: Y Rameswara Reddy, B Chandra Mohan Reddy

The work presents optimization of process parameters in wire electrical discharge machining process. This paper presents the results of experimental work carried out in Wire Electrical Discharge Machining of Super Ni 718 super alloy. Experiments have been conducted using 8 process parameters such as Pulse on time, Spark gap, Wire feed, Wire tension, flushing pressure, servo speed and peak current at 3 levels for obtaining responses like surface finish, material removal rate and dimensional deviation. The optimal setting of parameters is determined through experiments planned, conducted and analyzed using Neutrosophic sets and TOPSIS method.

Comments: 7 Pages.

Download: PDF

Submission history

[v1] 2018-08-22 02:44:28

Unique-IP document downloads: 4 times

Vixra.org is a pre-print repository rather than a journal. Articles hosted may not yet have been verified by peer-review and should be treated as preliminary. In particular, anything that appears to include financial or legal advice or proposed medical treatments should be treated with due caution. Vixra.org will not be responsible for any consequences of actions that result from any form of use of any documents on this website.

Add your own feedback and questions here:
You are equally welcome to be positive or negative about any paper but please be polite. If you are being critical you must mention at least one specific error, otherwise your comment will be deleted as unhelpful.

comments powered by Disqus